CEMHER MICROCEMENT MESH (10-50m2)
Size (m2)
$29.00 AUD
$98.90 per m2
DESCRIPTION
Premium reinforcement mesh engineered for CEMHER systems to improve strength, stability and long-term performance. While CEMHER microcement is highly flexible, Micro Mesh adds a reinforcing layer within the system, extra insurance where movement and stress are highest.
WHERE TO USE
- Required on: floors, wet areas, benchtops, over FC/MDF/ply
- Not required: standard Microne feature walls (unless specified).
COMPATIBILITY
Use CEMHER Micro-mesh 80gsm only. Heavier or non-compatible meshes can impair adhesion, upset film build/coverage and compromise the finish.
Always use Primer100 and the applicable Cemher system as specified.
SIZES
- 100 cm × 50 m roll — 50 m² coverage
- 20 cm × 50 m roll — 10 m² coverage (banding/joints/edges)
Levels Build
Anti-Crack
Durability & Flex
80gsm Fibreglass
PRIMER
Roll Primer100 onto the prepared substrate
1
MESH
Lay mesh curved/rolled side down onto the tacky Primer100
2
ROLL
Roll over the mesh to tack it down and bond it.
3
DRY
Allow to tack/flash/Dry 1hr, then apply CEMHER Microcement Base coats as specified.
4
PURPOSE
WHERE TO USE
SIZES
- Controls hairline cracking: spreads substrate movement so it doesn’t telegraph through the finish.
- Reinforces weak points: sheet joints, edges, transitions etc.
- Adds toughness: better impact and abrasion resistance on floors/benchtops/bathrooms.
- Levels the build: helps keep base coats a consistent height across the surface.
- Required on: floors, wet areas, benchtops, over FC/MDF/ply
- Not required: standard Microne feature walls (unless specified).
- 100 cm × 50 m roll — 50 m² coverage
- 20 cm × 50 m roll — 10 m² coverage (banding/joints/edges)
